Generador de ajustes de impresora Zebra

Crea fragmentos ZPL y SGD para tareas comunes de configuración Zebra antes de probar en el dispositivo real.

^PW^LL~SD^PR

Ajustes de impresora

ZPL / SGD

Ancho en puntos (^PW)

Largo en puntos (^LL)

Oscuridad 0-30 (~SD)

Velocidad de impresión (^PR)

Orientación

Media type

Print configuration label (~WC)Run media calibration (~JC)

Send settings only to printers you control. Test on non-production media first because darkness, speed and calibration affect real labels.

Device setup

Width812

Darkness15

Speed4

ZPL / SGD command output

^XA
^PW812
^LL1218
~SD15
^PR4
^PON
! U1 setvar "ezpl.print_method" "t"
~WC
^XZ

Production safety note

These commands may change physical printer behavior. Verify values against your printer model, media and ribbon before using in production.

Enter label and printer values

Set width, length, darkness, speed, orientation and media type for your Zebra printer.

Generate setup commands

The tool outputs common ZPL and SGD commands that can be sent to controlled devices.

Test on real hardware

Print a configuration label or test media before rolling settings into production workflows.

~SD controls print darkness. Higher values print darker, but too much darkness can reduce barcode quality.

^PW sets print width in dots. Match it to your label width and printer DPI.

No. This page generates commands only. Copy them into your trusted printing workflow or device management tool.

The output includes a common SGD print-method command alongside ZPL commands where useful.