Générateur de réglages imprimante Zebra

Créez des snippets ZPL et SGD pour les réglages courants Zebra avant test sur appareil réel : largeur, longueur, densité, vitesse, orientation et média.

^PW^LL~SD^PR

Réglages imprimante

ZPL / SGD

Largeur en points (^PW)

Longueur en points (^LL)

Densité 0-30 (~SD)

Vitesse d’impression (^PR)

Orientation

Media type

Print configuration label (~WC)Run media calibration (~JC)

Send settings only to printers you control. Test on non-production media first because darkness, speed and calibration affect real labels.

Commandes générées

Device setup

Width812

Darkness15

Speed4

ZPL / SGD command output

^XA
^PW812
^LL1218
~SD15
^PR4
^PON
! U1 setvar "ezpl.print_method" "t"
~WC
^XZ

Production safety note

These commands may change physical printer behavior. Verify values against your printer model, media and ribbon before using in production.

Generate printer settings in three steps

Enter label and printer values

Set width, length, darkness, speed, orientation and media type for your Zebra printer.

Generate setup commands

The tool outputs common ZPL and SGD commands that can be sent to controlled devices.

Test on real hardware

Print a configuration label or test media before rolling settings into production workflows.

Questions Fréquemment Posées

~SD controls print darkness. Higher values print darker, but too much darkness can reduce barcode quality.

^PW sets print width in dots. Match it to your label width and printer DPI.

No. This page generates commands only. Copy them into your trusted printing workflow or device management tool.

The output includes a common SGD print-method command alongside ZPL commands where useful.