Penasihat Kualitas Cetak Termal

Diagnosis cetak pudar, terlalu gelap, barcode gagal dipindai, noda, dan garis horizontal.

Cetak termalUji lapanganPemeriksaan sebelum cetak

Settings

203 DPI

SymptomPrinter DPI

Use the advisor as a fast triage checklist. Change one variable at a time so the real cause is visible.

Results

Uji lapangan

Likely causes

Darkness or heat is too low for the media.
Print speed is too high for the ribbon or direct-thermal stock.
Media or ribbon does not match the print method.

Recommended actions

Raise darkness gradually and test one label.
Lower print speed and compare barcode edges.
Clean the printhead with approved wipes after power-off cooldown.
Confirm direct thermal vs thermal transfer mode and ribbon orientation.

Symptom: Faded or pale print
DPI: 203

Likely causes
- Darkness or heat is too low for the media.
- Print speed is too high for the ribbon or direct-thermal stock.
- Media or ribbon does not match the print method.

Recommended actions
- Raise darkness gradually and test one label.
- Lower print speed and compare barcode edges.
- Clean the printhead with approved wipes after power-off cooldown.
- Confirm direct thermal vs thermal transfer mode and ribbon orientation.

Cara menggunakan

Tempel contoh

Paste real printer data from a POS, WMS, ERP, driver log, or template.

Tinjau hasil

Review parsed commands, generated text, checklists, or recommended fixes.

Uji sebelum produksi

Use the result to reduce test prints, then confirm final output with the target printer and media.

Thermal Print Quality Advisor FAQ

No. It helps catch common script, media, and setup issues earlier, but final validation still belongs on real hardware.

The lightweight parsing and generation run in the browser UI.

Firmware, DPI, media, ribbon, printhead condition, and driver settings can change the final print.