Trợ lý hiệu chuẩn máy in

Chọn ngôn ngữ máy in và loại vật liệu để lấy lệnh hiệu chuẩn cùng checklist cảm biến.

In nhiệtKiểm tra trước khi inKhông cần tải lên

Settings

ZPL

LanguageMedia type

Review commands before sending them to a printer. Calibration can feed labels and may change saved printer settings.

Review first

^XA
^MNY
^JUS
^XZ
~JC

Load the actual label stock and ribbon that production will use.

For gap labels, make sure the gap is visible to the sensor and labels are not curled.

Clean the media sensor and platen before assuming the template is wrong.

Run a feed test and confirm each label stops at the same tear or peel position.

Save settings only after the sensor reliably detects the label start.

Dán mẫu

Paste real printer data from a POS, WMS, ERP, driver log, or template.

Xem kết quả

Review parsed commands, generated text, checklists, or recommended fixes.

Kiểm thử trước sản xuất

Use the result to reduce test prints, then confirm final output with the target printer and media.

No. It helps catch common script, media, and setup issues earlier, but final validation still belongs on real hardware.

The lightweight parsing and generation run in the browser UI.

Firmware, DPI, media, ribbon, printhead condition, and driver settings can change the final print.